Avisos
Vaciar todo
Rob Meades
Rob Meades
Grupo: Registrado
Registrado: 2017/10/15
Estimable Member
4
FYI, that resin worked excellently, thanks for the recommend...

En el foro General discussion, announcements and releases

hace 2 months
That's great, thanks, and available from Amazon in the UK. ...

En el foro General discussion, announcements and releases

hace 2 months
SL1 and a hard resin

En el foro General discussion, announcements and releases

hace 2 months
One more update on this: I did have another filament blockag...

En el foro Hardware, firmware and software help

hace 3 months
FYI switching the "stuck filament" detector off did allow a ...

En el foro Hardware, firmware and software help

hace 3 months
Hmm, yes, leaving the door open a crack is a bit difficult w...

En el foro Hardware, firmware and software help

hace 3 months
Update: I've had the filament in an oven at 50 C for 24 hour...

En el foro Hardware, firmware and software help

hace 3 months
Thanks for the advice: the filament arrived (from Amazon) ye...

En el foro Hardware, firmware and software help

hace 3 months
Bubbles in filament

En el foro Hardware, firmware and software help

hace 3 months
To confirm: this absolutely did the trick. 5 minutes with a...

En el foro Hardware, firmware and software help

hace 4 months
OK blow torch it is!

En el foro Hardware, firmware and software help

hace 4 months
I suppose it's useless to me as it is, so no loss if I do da...

En el foro Hardware, firmware and software help

hace 4 months
OK, though I'll be afraid of going too far and damaging some...

En el foro Hardware, firmware and software help

hace 4 months
Filament load unable to perform "purge" stage after removal ...

En el foro Hardware, firmware and software help

hace 4 months
Combining these two replies I guess the answer could be to m...

En el foro General discussion, announcements and releases

hace 5 months
Interesting: printing solid parts is likely to be problemati...

En el foro General discussion, announcements and releases

hace 5 months
> After writing in a hurry about a glass plate I realized...

En el foro How do I print this? (Printing help)

hace 5 months
> Then we found out, that the real heatbed temperature of...

En el foro How do I print this? (Printing help)

hace 5 months
Aha, yes, of course, remove the arms :-).

En el foro How do I print this? (Printing help)

hace 5 months
> providing they don't restrict bed movement Unfortunatel...

En el foro How do I print this? (Printing help)

hace 5 months
Página 1 / 7
Compartir: