Čeština
Fóra
Uživatelé
Rob
Aktivita
 
Notifications
Clear all
Rob
Rob
Skupina: Registrovaný
Přidal se: 2018/09/25
Active Member
1
Profile Aktivita
To do this - change the "z offset" in the printer settings t...

In forum Assembly and first prints troubleshooting

 před 2 years
homing for every tool change

In forum Hardware, firmware and software help

 před 2 years
I checked mine with straightedge too. They look good.

In forum Assembly and first prints troubleshooting

 před 2 years
I just built my second XL yesterday and it's the same. I've ...

In forum Assembly and first prints troubleshooting

 před 2 years
Two issues going on here: Too high Z-offfset overall, at ran...

In forum Assembly and first prints troubleshooting

 před 2 years
My understanding of mesh levelling is that it would compensa...

In forum Assembly and first prints troubleshooting

 před 2 years
textured - with PETG. I also note the textured sheet has inc...

In forum Assembly and first prints troubleshooting

 před 2 years
Wouldn't the auto probe Z compensate for this?

In forum Assembly and first prints troubleshooting

 před 2 years
I'm getting the same thing across the rear of the bed. Facto...

In forum Assembly and first prints troubleshooting

 před 2 years
Textured Sheet: inconsistent Z height, overall too high

In forum Assembly and first prints troubleshooting

 před 2 years
For clarity - just changing the sheet didn't do the trick. t...

In forum Hardware, firmware and software help

 před 2 years
what's the correct procedure for switching sheets?

In forum Hardware, firmware and software help

 před 2 years
I'm talking about one part with small and large areas where ...

In forum PrusaSlicer

 před 3 years
Change order of parts output on first layer?

In forum PrusaSlicer

 před 3 years
MINI keeps changing filament for no reason

In forum Hardware, firmware and software help

 před 5 years
What's the official method for fixing stickiness of PEI-coat...

In forum Hardware, firmware and software help

 před 7 years
Share: