Activity
 
Notifications
Clear all
Rob
Rob
Group: Registered
Joined: 2018/09/25
Active Member
1
To do this - change the "z offset" in the printer settings t...

In forum Assembly and first prints troubleshooting

10 months ago
homing for every tool change

In forum Hardware, firmware and software help

10 months ago
I checked mine with straightedge too. They look good.

In forum Assembly and first prints troubleshooting

10 months ago
I just built my second XL yesterday and it's the same. I've ...

In forum Assembly and first prints troubleshooting

10 months ago
Two issues going on here: Too high Z-offfset overall, at ran...

In forum Assembly and first prints troubleshooting

1 year ago
My understanding of mesh levelling is that it would compensa...

In forum Assembly and first prints troubleshooting

1 year ago
textured - with PETG. I also note the textured sheet has inc...

In forum Assembly and first prints troubleshooting

1 year ago
Wouldn't the auto probe Z compensate for this?

In forum Assembly and first prints troubleshooting

1 year ago
I'm getting the same thing across the rear of the bed. Facto...

In forum Assembly and first prints troubleshooting

1 year ago
Textured Sheet: inconsistent Z height, overall too high

In forum Assembly and first prints troubleshooting

1 year ago
For clarity - just changing the sheet didn't do the trick. t...

In forum Hardware, firmware and software help

1 year ago
what's the correct procedure for switching sheets?

In forum Hardware, firmware and software help

1 year ago
I'm talking about one part with small and large areas where ...

In forum PrusaSlicer

2 years ago
Change order of parts output on first layer?

In forum PrusaSlicer

2 years ago
MINI keeps changing filament for no reason

In forum Hardware, firmware and software help

4 years ago
What's the official method for fixing stickiness of PEI-coat...

In forum Hardware, firmware and software help

6 years ago
Share: