Notifications
Clear all
rickwise
rickwise
Group: Registered
Joined: 2022/09/08
Eminent Member
2
That worked, thanks a million, Chris!

In forum Hardware, firmware and software help

2 months ago
MMU3 failed on filament 1

In forum Hardware, firmware and software help

2 months ago
I was finally able to get it to load, but it took 6 or 8 mor...

In forum Hardware, firmware and software help

3 months ago
My bad, not mentioning which printer. Thanks for responding...

In forum Hardware, firmware and software help

3 months ago
I looked for that setting, but can't find it. I'm running f...

In forum Hardware, firmware and software help

3 months ago
MMU3 not loading PETG

In forum Hardware, firmware and software help

3 months ago
Unload from nozzle failures

In forum Hardware, firmware and software help

8 months ago
Thanks, Joan. It works fine when I print from gcode exporte...

In forum PrusaSlicer

8 months ago
SIngle-filament print via octoprint

In forum PrusaSlicer

8 months ago
New look & feel for guides on prusa.com

In forum General discussion, announcements and releases

8 months ago
I did wonder about that: I assume the resonance is related t...

In forum General discussion, announcements and releases

8 months ago
The table is pretty beefy, and I'll add some mass to it. In...

In forum General discussion, announcements and releases

8 months ago
Verifying stability

In forum General discussion, announcements and releases

8 months ago
I checked the LCD and couldn't find anything. So I wrote a ...

In forum Hardware, firmware and software help

10 months ago
Excellent! I'll look for that as soon as this print finishe...

In forum Hardware, firmware and software help

10 months ago
Printer nags to update firmware

In forum Hardware, firmware and software help

10 months ago
Thanks for the point about the power panic: I'll have to loo...

In forum Hardware, firmware and software help

2 years ago
I agree with your points, and I would run the Prusa on batte...

In forum Hardware, firmware and software help

2 years ago
Running MK3+ on battery

In forum Hardware, firmware and software help

2 years ago
Thanks, Diem! That will be my plan B. I'm doing some exper...

In forum PrusaSlicer

3 years ago
Page 1 / 2
Share: