Notifications
Clear all
Ricksey007
Skupina: Registrovaný
Přidal se: 2021/09/29
Active Member
1
| This has been a great help. I will proceed with recalibrati... | před 5 months | |
| MK3.5S+ and MMU3 | před 5 months | |
| I have solved the problem of getting the registration code a... | před 7 months | |
| Prusa Connect | před 7 months | |
|
Power Outage Recovery In forum Hardware, firmware and software help |
před 7 months | |
| My bad, I have the i3MK3S+. But I did look again at the Pru... | před 2 years | |
| Prusa Link | před 2 years | |
| A lot of good info here, thanks. I will do some checking. | před 3 years | |
| Yes, I have a MK3S+. By PSU do you mean the Power Supply? ... | před 3 years | |
| Thanks for the reply. My first attempt was to put a copper ... | před 3 years | |
| Protecting from static discharge | před 3 years | |
|
Robin, Thanks for the help. In the end I replaced the Hea... In forum Hardware, firmware and software help |
před 3 years | |
|
Mintemp Bed Error Message In forum Hardware, firmware and software help |
před 3 years | |
|
Loading Filament In forum Hardware, firmware and software help |
před 4 years |