Notifications
Clear all
Rick
Rick
Skupina: Registrovaný
Přidal se: 2019/03/08
Trusted Member
3
PrusaSlicer 2.6.0 install on Mac does not work

In forum PrusaSlicer

před 1 year
That sounds like something that was fixed in 4.3.2. The bug ...

In forum General discussion, announcements and releases

před 2 years
The purge is likely a single instruction to feed some mm of ...

In forum Hardware, firmware and software help

před 4 years
I tried another USB drive and it worked. The one that wasn’t...

In forum Hardware, firmware and software help

před 4 years
I'm having the same issue. I put the new .bbf file on my USB...

In forum Hardware, firmware and software help

před 4 years
If a firmware update doesn’t work for you, go back to the ve...

In forum General discussion, announcements and releases

před 4 years
I shutter to think what your power supply might be overheari...

In forum General discussion, announcements and releases

před 4 years
Roll back to 3.9.2 and see if that resolves the issue.

In forum General discussion, announcements and releases

před 4 years
Submitted a bug report in Github. [BUG] File select from S...

In forum General discussion, announcements and releases

před 4 years
Finished the build of my new MK3S+ and printed the Marvin wh...

In forum General discussion, announcements and releases

před 4 years
I think the way you do this is to print your part, use that ...

In forum General discussion, announcements and releases

před 4 years
Typically the part cooling fan doesn’t run during the first ...

In forum General discussion, announcements and releases

před 4 years
They said that upgrade kits would be available in January. R...

In forum Hardware, firmware and software help

před 4 years
Ordered my kit on 22-Jun and it shipped today. No extras. Sp...

In forum General discussion, announcements and releases

před 4 years
Print fan error

In forum Assembly and first prints troubleshooting

před 4 years
@some-dude Thanks but I’m waiting for my MK3S kit. Ordered o...

In forum General discussion, announcements and releases

před 4 years
Looking at the orders spreadsheet, which may be less than ac...

In forum General discussion, announcements and releases

před 4 years
Yes but moisture in the filament should cause random imperfe...

In forum Assembly and first prints troubleshooting

před 4 years
I suspect the main focus when they hire programmers is that ...

In forum General discussion, announcements and releases

před 4 years
Open your g-code file with a text editor like notepad or tex...

In forum General discussion, announcements and releases

před 4 years
Stránka 1 / 5
Share: