Notifications
Clear all
redrock
Group: Registered
Joined: 2017/02/24
Active Member
1
|
God damn it, I will soon throw out this printer out of the w... In forum Prusa i3 kit (Archive) |
8 years ago | |
|
I will take some pictures of the header, assembly and printe... In forum Prusa i3 kit (Archive) |
8 years ago | |
|
I will take some pictures of the header, assembly and printe... In forum Prusa i3 kit (Archive) |
8 years ago | |
|
I have went as far down to 0.3mm, it still crashes in to the... In forum Prusa i3 kit (Archive) |
8 years ago | |
|
Here is a video of it
So during my tests my PINDA does not... In forum Prusa i3 kit (Archive) |
8 years ago | |
|
Ok, did some more calibration, and I think I found my proble... In forum Prusa i3 kit (Archive) |
8 years ago | |
|
I have tried from 2mm and down. And it´s catching on the sec... In forum Prusa i3 kit (Archive) |
8 years ago | |
|
Menu have started to act strange with latest firmware In forum Prusa i3 kit (Archive) |
8 years ago | |
|
XYZ calibration catches paper In forum Prusa i3 kit (Archive) |
8 years ago |