Activity
 
Notifications
Clear all
rcg3d
rcg3d
Group: Registered
Joined: 2020/11/23
Active Member
1
After reading my post, I realized that it might not be clear...

In forum How do I print this? (Printing help)

2 weeks ago
Flexible filaments (really flexible...)

In forum How do I print this? (Printing help)

2 weeks ago
Thanks. I will check firmware and try a different USB stick...

In forum Hardware, firmware and software help

9 months ago
It's been slow since I set up the printer. Maybe the USB st...

In forum Hardware, firmware and software help

9 months ago
Super Slow Uploads

In forum Hardware, firmware and software help

9 months ago
No worries, I did scan the forum to see if there was a topic...

In forum Introduction & Instructions

2 years ago
Thanks! I did mange to find a couple of Pi's at home, but I...

In forum Introduction & Instructions

2 years ago
Alternative Micro computers?

In forum Introduction & Instructions

2 years ago
RE: Reboots when bed heats

In forum Hardware, firmware and software help

2 years ago
Both heater outputs run at 24VDC when turned on with the hea...

In forum Hardware, firmware and software help

2 years ago
Reboots when bed heats

In forum Hardware, firmware and software help

2 years ago
Thank you. Someone in our company actually had ordered some...

In forum Hardware, firmware and software help

2 years ago
Hotend only partially heating

In forum Hardware, firmware and software help

2 years ago
My colleague printed some parts with a lowered temp down abo...

In forum Hardware, firmware and software help

4 years ago
Some printers print with difficult to remove support

In forum Hardware, firmware and software help

4 years ago
Share: