Notifications
Clear all
RandomDude
Skupina: Registrovaný
Přidal se: 2022/08/21
Active Member
1
| If that is the case then I assume that one should be able to... | před 2 years | |
| Just an update for anyone finding this post: This issue is n... | před 2 years | |
| My understanding is that the ICSP header uses the same speed... | před 2 years | |
| I just tried the ArcWelder plugin to OctoPrint, it seems to ... | před 3 years | |
| SD card results in smooth prints because it uses much faster... | před 3 years | |
| I did some tests with Prusa i3 MK3S with firmware 3.12.2, an... | před 3 years | |
| Has issues with slow USB/UART been solved so I can use OctoP... | před 3 years | |
|
Looks nice! A few features that I had hoped for: Custom loca... In forum PrusaSlicer |
před 3 years | |
|
I opened a new issue as it seems the old one has not been so... In forum PrusaSlicer |
před 3 years | |
|
How to disable viewing of Custom G-code? (Messes up width pr... In forum PrusaSlicer |
před 3 years |