Notifications
Clear all
pug
Skupina: Registrovaný
Přidal se: 2024/11/23
Active Member
1
| PETG lifting on one side only (Ender 3) | před 3 weeks | |
|
Dropping down the 70 on that line to a much small number wor... In forum PrusaSlicer |
před 9 months | |
|
@neophyl thank you, this helped a bit, but the printhead is ... In forum PrusaSlicer |
před 9 months | |
|
Ender 3 pro. Confirmed I am in expert mode (just not an expe... In forum PrusaSlicer |
před 9 months | |
|
How do I set the GCODE macros to not raise the printhead so ... In forum PrusaSlicer |
před 9 months | |
|
Can't log in on Prusa Slicer 2.8.1 on Flatpak In forum PrusaSlicer |
před 11 months |