Benachrichtigungen
Alles löschen
prusanewuser
prusanewuser
Gruppe: Registriert
Beigetreten: 2018/02/03
Prominent Member
2
Thanks. Perhaps I did that too earlier. Will keep an eye on ...

Im Forum General discussion, announcements and releases

Vor 4 years
@karl-herbert I noticed that static shock happened often in ...

Im Forum General discussion, announcements and releases

Vor 4 years
The problem I have currently is: I also have the problem th...

Im Forum General discussion, announcements and releases

Vor 4 years
Very strange sound when loading filament

Im Forum General discussion, announcements and releases

Vor 4 years
Very poor support staff

Im Forum General discussion, announcements and releases

Vor 4 years
About an hour after the print job finished, I went back to s...

Im Forum General discussion, announcements and releases

Vor 4 years
@bobstro Do you think the LCD issues are caused by static? D...

Im Forum General discussion, announcements and releases

Vor 4 years
Why the printer changes the target temperature I set in Tune...

Im Forum General discussion, announcements and releases

Vor 4 years
Static shocks and garbage letters on the LCD screen

Im Forum General discussion, announcements and releases

Vor 4 years
@bobstro Thank you. Not sure why I had 0 mm in LiftZ. Shall...

Im Forum PrusaSlicer

Vor 4 years
@bobstro Thanks but I already increased Lift Z from 0 to 0.6...

Im Forum PrusaSlicer

Vor 4 years
@bobstro Thanks for the nice illustration. Am I correct that...

Im Forum General discussion, announcements and releases

Vor 4 years
Hi @bobstro , where is the top of the heater block (any pho...

Im Forum General discussion, announcements and releases

Vor 4 years
Combing and Retraction parameters to get rid of scars

Im Forum PrusaSlicer

Vor 4 years
Why Prusa always have issues with shipping the MMU?

Im Forum General discussion, announcements and releases

Vor 4 years
What is the problem of using PolyDissolve S1 with MMU2S?

Im Forum General discussion, announcements and releases

Vor 4 years
Most of the time when I contacted Support, they asked me to ...

Im Forum General discussion, announcements and releases

Vor 4 years
For other printers I have used, auto leveling was done autom...

Im Forum General discussion, announcements and releases

Vor 4 years
Why Prusa does not add auto bed leveling feature to i3 MK3/S...

Im Forum General discussion, announcements and releases

Vor 4 years
@joantabb Thanks. Does the surface look smooth if using PLA ...

Im Forum General discussion, announcements and releases

Vor 4 years
Seite 21 / 40
Teilen: