Notifications
Clear all
Print McPrinty
Print McPrinty
Group: Registered
Joined: 2017/02/28
Active Member
1
For me the issue was the PTFE tube in the extruder. I accide...

In forum Hardware, firmware and software help

4 years ago
All lights flashing at completion of print.

In forum Assembly and first prints troubleshooting

5 years ago
Turns out that replacing the PFTE tube in the extruded made ...

In forum Hardware, firmware and software help

5 years ago
Anyone still having these issues? I have been struggling wit...

In forum Hardware, firmware and software help

5 years ago
So I've looked for any friction points and added compression...

In forum General discussion, announcements and releases

5 years ago
Thanks very much for this info. I did totally re-position th...

In forum General discussion, announcements and releases

5 years ago
I adjusted the sensor so it is properly registering 0 and 1 ...

In forum General discussion, announcements and releases

5 years ago
Thanks for the reply and the tip. What I'm seeing that the f...

In forum General discussion, announcements and releases

5 years ago
I've also been having some trouble with the tips. I seem to ...

In forum General discussion, announcements and releases

5 years ago
True but when I lower the PINDA it seems too close to the be...

In forum Assembly and first prints troubleshooting

7 years ago
So I felt the Pinta probe was a bit low and was catching on ...

In forum Assembly and first prints troubleshooting

7 years ago
Yep, It was off by 5mm or so. I adjusted the Extrusion Multi...

In forum Assembly and first prints troubleshooting

7 years ago
I haven't calibrated the extruder so I will do that. I actua...

In forum Assembly and first prints troubleshooting

7 years ago
I'm using Sli3r Prusa edition. The PLA sticks ok now on the ...

In forum Assembly and first prints troubleshooting

7 years ago
Yeah good point. I am having trouble getting the PLA to stic...

In forum Assembly and first prints troubleshooting

7 years ago
Having trouble with the base layer ends curling up. Seems to...

In forum Assembly and first prints troubleshooting

7 years ago
Same here, I can print PLA just fine but I get the error whe...

In forum Prusa i3 kit (Archive)

8 years ago
Share: