|
Good morning! To follow up on this, my new sheet arrived yes... In forum Hardware, firmware and software help |
1 year ago |
|
Morning. Not sure what that could be. The printer is inside ... In forum Hardware, firmware and software help |
1 year ago |
|
Alright, lots of photos. Here's a test of three cubes at dif... In forum Hardware, firmware and software help |
1 year ago |
|
Nope, no modifiers. I'll give the deep soap clean a try and ... In forum Hardware, firmware and software help |
1 year ago |
|
It's a simple 20mm square test cube, from here. 3MF is attac... In forum Hardware, firmware and software help |
1 year ago |
|
Strange, thought I'd included those pictures. Here's the ima... In forum Hardware, firmware and software help |
1 year ago |
|
Pitting on print facing build plate In forum Hardware, firmware and software help |
1 year ago |
|
Thanks! Odd that this lined up with the hotend rebuild, gues... In forum How do I print this? (Printing help) |
2 years ago |
|
I had one unopened package of filament, Hatchbox PETG in Bla... In forum How do I print this? (Printing help) |
2 years ago |
|
I'm not positive what you mean by seam settings. The positio... In forum How do I print this? (Printing help) |
2 years ago |
|
Perimeter Problems after Hotend Replacement In forum How do I print this? (Printing help) |
2 years ago |
|
Thanks for the gut-check. I'll reach out to Prusa Support an... In forum Hardware, firmware and software help |
3 years ago |
|
Tried that and no dice.
Printer had been off for about eig... In forum Hardware, firmware and software help |
3 years ago |
|
I run prints with the door closed, opened it to take the vid... In forum Hardware, firmware and software help |
3 years ago |
|
MKS3+ Extruder Issues In forum Hardware, firmware and software help |
3 years ago |
|
The plot thickens. An additional print in the same location ... In forum How do I print this? (Printing help) |
3 years ago |
|
Did a few things to try to fix this. Cleaned the print sheet... In forum How do I print this? (Printing help) |
3 years ago |
|
Warping/bubbling on Top Surface for print that used to run f... In forum How do I print this? (Printing help) |
3 years ago |
|
Print gets striations at the end In forum Assembly and first prints troubleshooting |
4 years ago |
