PJR – Activité – Prusa3D Forum

Notifications

Clear all

PJR

Groupe: Modérateur

A(ont) rejoint: 2015/06/01

Titre: Antient Member Moderator

	Hi Angus/David I have a Chinese clone running 1.75mm which ... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Apologies for that; I have checked the MAXTEMP settings... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Tim I really don't think this is a Rambo issue. And from y... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Ruud These things will always prove useful, even the che... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	There is another option - use a spacer at the corners betwee... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Angus The more I read about your problem, the more I am con... Dans le forum Software (Archive)	il y a 10 years
	Ruud Have you taken the fuses out and checked them for cont... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi The heated beds can be bought from eBay for less than £7... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Not sure about this but can the hot bed be installed ups... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Ruud I believe that both hot end and bed heaters are of ... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Ami That's great. You really are doing well. Some of t... Dans le forum Software (Archive)	il y a 10 years
	Hi Robert That is indeed great news, and it's good to know ... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Tim Better tip for PLA: Blue tape. Works every time, al... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Tim I have started using Octoprint today. I have notice... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Angus One more thought... Is le printer located where t... Dans le forum Software (Archive)	il y a 10 years
	Hi Mathew For checking hot end temperature, I use an IR the... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi Ami Great news and very well done. The hub is definitel... Dans le forum Software (Archive)	il y a 10 years
	OK then, I think your best bet is to contact PR directly as ... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Hi I don't think anything is supposed to fit directly on to... Dans le forum Prusa i3 kit (Archive)	il y a 10 years
	Petr Sorry I disagree The last thing anyone (especially so... Dans le forum Software (Archive)	il y a 10 years

Page 280 / 281 Précédent Suivant

Statistiques du forum

598 Forums

71 K Sujets

497.7 K Messages

13 En-ligne

82.3 K Membres

Le dernier des messages: Filament fails to feed after ~45 minutes consistently. Notre nouveau membre: Teen Patti Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé