PJR – Activité – Prusa3D Forum

Notifications

Clear all

PJR

Groupe: Modérateur

A(ont) rejoint: 2015/06/01

Titre: Antient Member Moderator

	Hi Janis I think most of us have had that... I think the b... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Bradley Been thinking about the best way to get this sorted... Dans le forum Others (Archive)	il y a 9 years
	Keri Pleasure to help. This sort of thing does happen but... Dans le forum Others (Archive)	il y a 9 years
	You can change the steps/mm in Configuration_prusa.h #defin... Dans le forum Others (Archive)	il y a 9 years
	Keri You probably got the nozzle inserted wrong. There ar... Dans le forum Others (Archive)	il y a 9 years
	Scott The Mk2 kit may have the new heater with a plug alrea... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	(doesnt help that i have bad flair ups of arthritis in my ha... Dans le forum Others (Archive)	il y a 9 years
	Yeah, it gets stored in EEPROM, so not needed in GCode. It ... Dans le forum Others (Archive)	il y a 9 years
	Hi Darryl Great news and thanks for letting us know. Enjoy... Dans le forum Others (Archive)	il y a 9 years
	Hi Scott That can also happen if the connector has been han... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Hi Another vote for filament feed issues! Probably best to... Dans le forum Others (Archive)	il y a 9 years
	Z Hop or Lift is where the printhead is lifted during a move... Dans le forum Others (Archive)	il y a 9 years
	Erron Yes, I did consider that, but then I thought that as ... Dans le forum Others (Archive)	il y a 9 years
	Jay You could always put a 3mm cork tile under the heater. ... Dans le forum Others (Archive)	il y a 9 years
	Hi I have the "Live Adjust" available when the printer is i... Dans le forum Others (Archive)	il y a 9 years
	Patrick I think that is good news. Well done. Peter Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Hi Noel This forum is specifically to the "original" Prusa ... Dans le forum Print tips (Archive)	il y a 9 years
	Just built my kit this afternoon. Took it easy because I ha... Dans le forum Others (Archive)	il y a 9 years
	Yeah, seems to be all fixed now. My kit was shipped out las... Dans le forum Others (Archive)	il y a 9 years
	Steve The Mk2 is well worth going for. Just built mine tod... Dans le forum Prusa i3 kit (Archive)	il y a 9 years

Page 221 / 281 Précédent Suivant

Statistiques du forum

595 Forums

68.7 K Sujets

481 K Messages

15 En-ligne

77.2 K Membres

Le dernier des messages: 5T XL - Never passes stuck filament or bed leveling anymore Notre nouveau membre: mike Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé