PJR – Activité – Prusa3D Forum

Notifications

Clear all

PJR

Groupe: Modérateur

A(ont) rejoint: 2015/06/01

Titre: Antient Member Moderator

	Yeah, the printer will just sit waiting. In theory it shoul... Dans le forum Print tips (Archive)	il y a 9 years
	Is it just the X axis that is wrong? Is the belt tight? Ar... Dans le forum Others (Archive)	il y a 9 years
	Richard GCode commands should do exactly what they have bee... Dans le forum Others (Archive)	il y a 9 years
	Hi Damian Ditto what David said. Printing ABS requires a m... Dans le forum Others (Archive)	il y a 9 years
	Patrik That look like over-extrusion at the tip. Can you u... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Patrik The top layer of the background was also opposite. ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Patrik Question: Was the logo printed from the supplied GC... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Patrik It would appear to be under-extrusion, but there are... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Patrik It is very important that you set your printer up in... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Craig Here's the link: (or use eBay etc) Best to get 2 or... Dans le forum Others (Archive)	il y a 9 years
	David No it has only been amended and not fixed. A G28 Z0 ... Dans le forum Others (Archive)	il y a 9 years
	Ryan Download the latest driver and install them - the driv... Dans le forum Others (Archive)	il y a 9 years
	Hi Thomas I really don't think that matters too much, altho... Dans le forum Others (Archive)	il y a 9 years
	Patrik No need to disassemble the Y frame. 1. using the n... Dans le forum Others (Archive)	il y a 9 years
	Patrik I don't think first layer over-extrusion is somethin... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Patrik I think your first layer at 0.3mm would probably be ... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Stegosaurus - 1/12th scale Dans le forum Awesome prints (Hall Of Fame)	il y a 9 years
	should this fan always be on while printing? Damian The p... Dans le forum Others (Archive)	il y a 9 years
	Patrik That first layer is just slightly too high. You can... Dans le forum Prusa i3 kit (Archive)	il y a 9 years
	Erron One more thought on why this happens; could be due to... Dans le forum Others (Archive)	il y a 9 years

Page 218 / 281 Précédent Suivant

Statistiques du forum

595 Forums

68.7 K Sujets

480.9 K Messages

13 En-ligne

77.2 K Membres

Le dernier des messages: Really, Prusa? Notre nouveau membre: mike Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé