|
In all honesty, it is probably best to ignore the stats comp... In forum Prusa i3 kit (Archive) |
9 years ago |
|
A good square is the one in your last photo, left of the bed... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Pi. Low current draw (cheap to run) and not subject to rebo... In forum Hardware, firmware and software help |
9 years ago |
|
Here you go:
To set the extruder steps:
M92 Enumber_of_s... In forum Others (Archive) |
9 years ago |
|
Jerry
The filament will not be stuck to the PTFE. Id you r... In forum Prusa i3 kit (Archive) |
9 years ago |
|
What you have at the moment is a working printer which could... In forum Prusa i3 kit (Archive) |
9 years ago |
|
There are only STL and SCAD files available here:
Peter In forum Improvements (Archive) |
9 years ago |
|
Yes, that can happen, along with the clocks on the rotary en... In forum Hardware, firmware and software help |
9 years ago |
|
Increase the PSU output voltage to 12.5/13 volts?
How can i... In forum Hardware, firmware and software help |
9 years ago |
|
Nico
What are your current settings for Live Z adjust, and ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
Hardened steel has somewhat different thermal behaviour to t... In forum Others (Archive) |
9 years ago |
|
Jeff
I believe that user richard.l has been using a Micro S... In forum Others (Archive) |
9 years ago |
|
I'm using a mac ... and normally I really quit fond of using... In forum Others (Archive) |
9 years ago |
|
Funny question Peter, but why is there no centre option for ... In forum Others (Archive) |
9 years ago |
|
Rickey
The heated bed, when properly working, should measur... In forum Others (Archive) |
9 years ago |
|
I have printed all heights and sizes and pla and abs in sile... In forum Others (Archive) |
9 years ago |
|
Daniel
Looks like you need to disassemble the extruder to c... In forum Others (Archive) |
9 years ago |
|
David
Low power mode has never had any effect on the heater... In forum Hardware, firmware and software help |
9 years ago |
|
Jerry
The original fan can be used instead of the one with ... In forum Prusa i3 kit (Archive) |
9 years ago |
|
David
You don't take anything off to clean with Atomic Meth... In forum Prusa i3 kit (Archive) |
9 years ago |
