Prusa3D Forum

Notifications

Clear all

PixelPerfectCT

Groupe: Enregistré

A(ont) rejoint: 2017/08/29

Eminent Member

	So further testing and I have found that putting a fan on th... Dans le forum Others (Archive)	il y a 7 years
	they have no problem sending them to people who review on yo... Dans le forum Others (Archive)	il y a 7 years
	i figured it out, its a firmware issue! I was on the latest... Dans le forum Others (Archive)	il y a 7 years
	Tried a print at .2 layer height and didn’t have issues till... Dans le forum Others (Archive)	il y a 7 years
	cleaned my nozzle and did a cold pull that came out clean. t... Dans le forum Others (Archive)	il y a 7 years
	Bought the printer from prusa. It’s not a E3D issue I don’t ... Dans le forum Others (Archive)	il y a 7 years
	I cant seem to get anything to stick to my PEI sheet anymore... Dans le forum Others (Archive)	il y a 7 years
	I cant seem to get anything to stick to my PEI sheet anymore... Dans le forum Others (Archive)	il y a 7 years
	I have this same issue, cold pulls look like the above ones.... Dans le forum Others (Archive)	il y a 7 years
	I'm using a Raspberry Pi 3 hard wired to the ensy board, usi... Dans le forum Others (Archive)	il y a 7 years
	It's hard to post fails when all my prints are perfect. My M... Dans le forum Others (Archive)	il y a 7 years
	MK3 Fails (post your pics) Dans le forum Others (Archive)	il y a 7 years
	my cable chain for the bed binds on the rod, think I have t... Dans le forum Others (Archive)	il y a 7 years
	how are you printing to the mk3? usb, octoprint or SD card?... Dans le forum Others (Archive)	il y a 7 years
	I updated my firmware and still have loads of issues with oc... Dans le forum Others (Archive)	il y a 7 years
	Material blower fan doesn’t turn on Dans le forum Others (Archive)	il y a 7 years
	Blue PETG... Niiiice! Thanks! 😀 Really cool to see! ... Dans le forum Improvements (Archive)	il y a 7 years
	USB cable isn't the issue, tried several with the same resul... Dans le forum Others (Archive)	il y a 7 years
	Made this up today, printing it now to see how it works. see... Dans le forum Improvements (Archive)	il y a 7 years
	got these aswell, cant wait for the powder coated plates to ... Dans le forum Others (Archive)	il y a 7 years

Page 1 / 2 Suivant

Statistiques du forum

559 Forums

62.9 K Sujets

443 K Messages

23 En-ligne

67.7 K Membres

Le dernier des messages: Xl extruder stops Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé