Avisos
Vaciar todo
phillip.b7
Grupo: Registrado
Registrado: 2017/10/12
Active Member
1
|
How would I address these issues? En el foro How do I print this? (Printing help) |
hace 7 years | |
|
Trouble with printer layers En el foro How do I print this? (Printing help) |
hace 7 years | |
| I have a little doubt this is a clog, however it is not a no... | hace 8 years | |
| Cannot get Filament to Load | hace 8 years | |
| So manual loading does n work either. It really feels/seems ... | hace 8 years | |
| The autoload is dependent on the sensor working correctly. ... | hace 8 years | |
| if I straighten say 75mm of the filament end, it seems to fe... | hace 8 years | |
| The autoload is dependent on the sensor working correctly. ... | hace 8 years | |
| Troiuble Loading Filament | hace 8 years | |
| Thanks for the support all. I dialed by first layer calibrat... | hace 8 years | |
| Thanks for the feedback guys. I was getting concerned with t... | hace 8 years | |
| Oh, I am a reasonable computer tech, but I am brand new to 3... | hace 8 years | |
| Print not sticking to Hot Bed | hace 8 years |