Activity
 
Notifications
Clear all
phil_d
phil_d
Group: Registered
Joined: 2017/02/12
Active Member
1
Loosen the screws holding the PINDA probe in place until the...

In forum Others (Archive)

7 years ago
Hi Nathan, Yes, it is very likely a failed thermistor. I ha...

In forum Others (Archive)

7 years ago
Any electric motor can trip an arc fault circuit interrupter...

In forum Others (Archive)

7 years ago
I suspect that it's simply because ColorPrint is buggy and d...

In forum Software (Archive)

7 years ago
Very cool! Glad you got your printer back up and running and...

In forum Others (Archive)

7 years ago
Hi Jon, You will have to replace the thermistor. If you liv...

In forum Others (Archive)

7 years ago
Here are the photos of how I placed the connector. Note the ...

In forum Others (Archive)

7 years ago
As far as whether it is safe to cut and solder, I can't give...

In forum Others (Archive)

7 years ago
Hi Chris, Great question. It's one I wish I had asked befor...

In forum Others (Archive)

7 years ago
It was indeed the PINDA probe. Just replaced it and the prin...

In forum Prusa i3 kit (Archive)

7 years ago
Thanks. Yeah, the extruder must be disassembled before blast...

In forum Prusa i3 kit (Archive)

7 years ago
You can preheat the extruder and heat bed to any temperature...

In forum Others (Archive)

7 years ago
Nozzle too high

In forum Prusa i3 kit (Archive)

7 years ago
Removing thermister cartridge from hotend

In forum Prusa i3 kit (Archive)

7 years ago
Check that there isn't excess (more than a few millimeters) ...

In forum Others (Archive)

7 years ago
I'm glad that was helpful. I'm pretty new to this, too, so I...

In forum Others (Archive)

8 years ago
This happened to me, too. In my case, there was too much of ...

In forum Others (Archive)

8 years ago
Ordered kit with orange parts on Feb 12. I received my shipp...

In forum General discussion, announcements and releases

8 years ago
Ordered kit with orange parts on Feb 12. I received my shipp...

In forum General discussion, announcements and releases

8 years ago
Share: