Prusa3D Forum

Notifications

Clear all

Phil

Skupina: Registrovaný

Přidal se: 2015/11/29

Eminent Member

	@merrill-a Thank you very much for having sent such a detail... In forum Coronavirus (COVID-19)	před 5 years
	@merrill-a Well done! I have a Cameo too but haven't found t... In forum Coronavirus (COVID-19)	před 5 years
	Some excellent support by the Prusa team helped me fix the p... In forum Hardware, firmware and software help	před 5 years
	Heater cartridge not warming up - everything else's fine // ... In forum Hardware, firmware and software help	před 5 years
	@fred-m8 Are these easy to cut and if so, how do you cut the... In forum Coronavirus (COVID-19)	před 5 years
	Face Shield - Laser cutting // Photonics 7+W In forum Coronavirus (COVID-19)	před 5 years
	@Joan: Many thanks for having taken the time to reply. Unfor... In forum Assembly and first prints troubleshooting	před 7 years
	Stiffening the extruder cable 3mm - alternatives to 3mm nylo... In forum Assembly and first prints troubleshooting	před 7 years
	@David: Many thanks for your reply and your help with this.... In forum Assembly and first prints troubleshooting	před 7 years
	Problem after upgrade MK2 -> MK2S In forum Assembly and first prints troubleshooting	před 7 years
	Thank you all for the great suggestions. Much appreciated! In forum Prusa i3 kit (Archive)	před 8 years
	If anyone else is still experiencing the same issue, I've ma... In forum Prusa i3 kit (Archive)	před 8 years
	Many thanks to all for your help. It's appreciated. To clar... In forum Prusa i3 kit (Archive)	před 8 years
	PEI Sheet damaged - Where do you buy limonene? In forum Prusa i3 kit (Archive)	před 8 years
	Thank you both. I've just chatted with Dan who requested som... In forum Prusa i3 kit (Archive)	před 9 years
	Upgrading to MK2 / PSU different from picture In forum Prusa i3 kit (Archive)	před 9 years
	@Joseph: Thanks for this. Would be great to have the same se... In forum Print tips (Archive)	před 9 years
	Mystery solved 😉 Thanks a lot, Josef! With regard to th... In forum Prusa i3 kit (Archive)	před 9 years
	Hi Peter, Thanks for the quick reply and for your help. I w... In forum Prusa i3 kit (Archive)	před 9 years
	Settings -> Calibrate Z In forum Prusa i3 kit (Archive)	před 9 years

Stránka 1 / 2 Další

Fórum Statistiky

565 Fóra

63.6 K Témata

446.2 K Příspěvky

20 Online

68.9 K Uživatelé

Poslední Příspěvek: Repeated Probing on right side of bed Nový Uživatel: Kiley Murphy Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed