Prusa3D Forum

Notifications

Clear all

PeterArnoldDesign

Group: Registered

Joined: 2021/10/24

Active Member

	Here is what I have done so far: replaced heat bed, thermist... In forum Hardware, firmware and software help	3 years ago
	Just checked continuity of cables from psu to heat bed, it a... In forum Hardware, firmware and software help	3 years ago
	Continuity is good for power from the psu to the einsy, as w... In forum Hardware, firmware and software help	3 years ago
	which wires do you think i should check? In forum Hardware, firmware and software help	3 years ago
	Just checked the f3 fuse. was hoping that this would be the ... In forum Hardware, firmware and software help	3 years ago
	Heatbed stopped heating up, issue persists after heatbed rep... In forum Hardware, firmware and software help	3 years ago
	Filament Not Extruding In forum Assembly and first prints troubleshooting	4 years ago

Forum Statistics

585 Forums

66.9 K Topics

469.2 K Posts

11 Online

74.6 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed