|
That benchy was with Overture PLA, I have had equally good ... In forum User mods - OctoPrint, enclosures, nozzles, ... |
před 3 years |
|
Is everyone having issues with their Revo Micro? For me it's... In forum User mods - OctoPrint, enclosures, nozzles, ... |
před 3 years |
|
Unless i'm mistaken, I think the fan speed is fixed. Apparen... In forum User mods - OctoPrint, enclosures, nozzles, ... |
před 3 years |
|
It doesn't recommend PID tuning, just says 'If you feel the ... In forum User mods - OctoPrint, enclosures, nozzles, ... |
před 3 years |
|
I think it might be these, but more reasonable with £4.95 de... In forum User mods - OctoPrint, enclosures, nozzles, ... |
před 3 years |
|
Yeah, 20€ for delivery, no thanks! In forum User mods - OctoPrint, enclosures, nozzles, ... |
před 3 years |
|
Would be happy to do this by a bit of trial and error, but t... In forum User mods - OctoPrint, enclosures, nozzles, ... |
před 3 years |
|
I cant see why this is simpler than just calculating the len... In forum User mods - OctoPrint, enclosures, nozzles, ... |
před 3 years |
|
Hi, I installed a Revo Micro on my Mini+ over the weekend, I... In forum User mods - OctoPrint, enclosures, nozzles, ... |
před 3 years |
|
Randomise position of print to extend print surface? In forum PrusaSlicer |
před 3 years |
|
I changed for a number of reasons. I had had a few cases of ... In forum How do I print this? (Printing help) |
před 3 years |
|
It’s working a treat now.
86F332B9-3311-421B-A716-6... In forum How do I print this? (Printing help) |
před 3 years |
|
OK, thank you, I am now getting decent prints. I'm always co... In forum How do I print this? (Printing help) |
před 3 years |
|
So I have done, a few days back, I'll definitely try again. In forum How do I print this? (Printing help) |
před 3 years |
|
So I checked and there's nothing under the sheet. The SuperP... In forum How do I print this? (Printing help) |
před 3 years |
|
So its securely screwed in, probably not as high as that, bu... In forum How do I print this? (Printing help) |
před 3 years |
|
That test was me doing the Live Z bed levelling as suggested... In forum How do I print this? (Printing help) |
před 3 years |
|
Now i'm really confused. The right-hand side is almost touch... In forum How do I print this? (Printing help) |
před 3 years |
|
Ok so I think my issus is that my bed is seriously not level... In forum How do I print this? (Printing help) |
před 3 years |
|
I did change the steps. I'll read the post, thanks In forum How do I print this? (Printing help) |
před 3 years |
