Notifications
Clear all
Paul beard
Paul beard
Grupa: Zarejestrowany
Dołączył: 2023/09/01
Trusted Member
3
This is actually a lot more useful than the zig zag lines te...

In forum Assembly and first prints troubleshooting

1 year temu
The side you are looking was on the bed. I have a new build ...

In forum How do I print this? (Printing help)

1 year temu
attached: 9 hour print job from today and the STL it was mad...

In forum How do I print this? (Printing help)

1 year temu
yes, soap and water are part of the routine. I think this pl...

In forum How do I print this? (Printing help)

1 year temu
file didn't attach to earlier reply…trying again.  e...

In forum How do I print this? (Printing help)

1 year temu
3mf file, two images of the aborted job, stopped when it sta...

In forum How do I print this? (Printing help)

1 year temu
OK, hold up…if the bed isn't level how am I only finding thi...

In forum How do I print this? (Printing help)

1 year temu
Two samples, top and bottom:  502e8564-img_8513....

In forum How do I print this? (Printing help)

1 year temu
The underside isn't that interesting, it's the top layer tur...

In forum How do I print this? (Printing help)

1 year temu
Sorry, I have done a factory reset/calibration and a bit of ...

In forum How do I print this? (Printing help)

1 year temu
I was on the verge of taking a video when it finally succeed...

In forum How do I print this? (Printing help)

1 year temu
No, it was not lifting off the bed at one end. It was adhere...

In forum How do I print this? (Printing help)

1 year temu
The build sheet is/was clean. The work piece didn't fall off...

In forum How do I print this? (Printing help)

1 year temu
why does my machine stop on the Z axis and scorch prints bef...

In forum How do I print this? (Printing help)

1 year temu
What makes a Prusa lose its z-height calibration?

In forum Hardware, firmware and software help

1 year temu
I'll wait. 3.11 seems fine.

In forum Hardware, firmware and software help

1 year temu
That is what I had assumed. Thank you.

In forum Others (Archive)

1 year temu
So it's Ok if the LED flickers during a job? I am seeing som...

In forum Others (Archive)

1 year temu
Yikes, I just updated the firmware on one of these in hopes ...

In forum Hardware, firmware and software help

1 year temu
Strona 4 / 4
Share: