|
I chatted with Prusa support for a couple of hours... They h... In forum Hardware, firmware and software help |
7 years ago |
|
Ok, I think it's temperature and seems to be aggravated by p... In forum Hardware, firmware and software help |
7 years ago |
|
You can also try the prusa support, since you have a pre-ass... In forum Hardware, firmware and software help |
7 years ago |
|
The two screws with the springs seemed appropriately tight. ... In forum Hardware, firmware and software help |
7 years ago |
|
Some more info:
I have printed a test object three times in... In forum Hardware, firmware and software help |
7 years ago |
|
Not sure exactly what you mean but no, I wasn't removing the... In forum Hardware, firmware and software help |
7 years ago |
|
So I was able to remove the jam, but on the next print it di... In forum Hardware, firmware and software help |
7 years ago |
|
Ah, one side of the enclosure for the pully (the "extruder i... In forum Hardware, firmware and software help |
7 years ago |
|
Thanks. It was about 30C ambient temp in there. Perhaps th... In forum Hardware, firmware and software help |
7 years ago |
|
No, this is just the Prusa gray PLA. The hot end fan seems ... In forum Hardware, firmware and software help |
7 years ago |
|
Filament jammed around pulley... In forum Hardware, firmware and software help |
7 years ago |
|
I have a more or less air-tight enclosure that is a 2' cube ... In forum Improvements (Archive) |
7 years ago |
|
Thanks, you are correct but what I found when my fan was in ... In forum Others (Archive) |
7 years ago |
|
Thanks - From what I've gathered i's a 5v DC 50mm x 15mm thr... In forum Others (Archive) |
7 years ago |
|
Since I'm dead in the water here at the moment I tried a few... In forum Hardware, firmware and software help |
7 years ago |
|
I also had better luck with the (current) S3D defaults than ... In forum General discussion, announcements and releases |
7 years ago |
|
U.S. Source / replacement for MK3 print fan? In forum Others (Archive) |
7 years ago |
|
The fan is fully dead now. Hoping to hear back from Prusa. In forum Hardware, firmware and software help |
7 years ago |
|
Ah, so it looks like the answer is yes, that is what will sh... In forum Others (Archive) |
7 years ago |
|
Will MMU pre-orders get new version shown recently? In forum Others (Archive) |
7 years ago |
