|
I usually use it at 36 to 38°C. In forum Hardware, firmware and software help |
1 week ago |
|
Since Prusa keeps insisting that overheating caused by my ho... In forum Hardware, firmware and software help |
1 week ago |
|
not in my case. But I can check again. I fully understand wh... In forum Hardware, firmware and software help |
3 weeks ago |
|
I cannot confirm that it's because of the fan. I had several... In forum Hardware, firmware and software help |
3 weeks ago |
|
I've been using ASA parts for several weeks now with no chan... In forum Hardware, firmware and software help |
1 month ago |
|
About the PCCF for the thermosensible parts. I used ASA, whi... In forum Hardware, firmware and software help |
1 month ago |
|
Just made a 3. try with PLA, no printbed temperature, no cha... In forum Hardware, firmware and software help |
2 months ago |
|
Hi, I've been having the same problem with one of five extru... In forum Hardware, firmware and software help |
2 months ago |
|
Hi.I have a similar issue with my XL more or less from the b... In forum Hardware, firmware and software help |
7 months ago |
|
Hi. It's been a while. Can you give us an update about this ... In forum Hardware, firmware and software help |
7 months ago |
