Prusa3D Forum

Notifications

Clear all

Omikron

Skupina: Registrovaný

Přidal se: 2016/06/16

Estimable Member

	I've been traveling too much to be able to set up mine yet, ... In forum Improvements (Archive)	před 10 years
	Me again! Been trying to get back to tinkering with the stl ... In forum Others (Archive)	před 10 years
	Just go to an auto store and buy a sample or small bottle of... In forum Prusa i3 kit (Archive)	před 10 years
	Is anybody else seeing issue with retraction settings being ... In forum General discussion, announcements and releases	před 10 years
	It's not the easiest in the world to use (at least for me), ... In forum Print tips (Archive)	před 10 years
	Great work, Martin! I will definitely be adding this to my ... In forum Improvements (Archive)	před 10 years
	Thanks, I haven't tried ABS yet. I jumped from PLA to PETG ... In forum Print tips (Archive)	před 10 years
	Can't disagree on that. Which is why I use only my cheapest ... In forum Others (Archive)	před 10 years
	Perhaps this is a bit too obvious of a response to be what y... In forum Print tips (Archive)	před 10 years
	I think it might be useful if Prusa Research were to publish... In forum Others (Archive)	před 10 years
	I've had good experiences using torx screwdriver bits in lie... In forum Others (Archive)	před 10 years
	My printer has been idle for about a week now, because I jus... In forum Print tips (Archive)	před 10 years
	Interesting thought. I had never really considered that. I ... In forum Print tips (Archive)	před 10 years
	Delrin, the plastic that is used for the z-nut that goes on ... In forum Prusa i3 kit (Archive)	před 10 years
	Stepping on beads isn't so bad, one of those little paper ba... In forum Print tips (Archive)	před 10 years
	what do you mean with your z-axis calibration is reset? I'm... In forum Prusa i3 kit (Archive)	před 10 years
	To my knowledge such a thing does not exist but boy would it... In forum Improvements (Archive)	před 10 years
	WD-40 is quite good for flushing out contaminants and old gr... In forum Others (Archive)	před 10 years
	Thanks for the tip on the cases for the center of the spool.... In forum Print tips (Archive)	před 10 years
	... before packing it in an airtight bag with a silca gel cy... In forum Print tips (Archive)	před 10 years

Stránka 1 / 11 Další

Fórum Statistiky

613 Fóra

71.9 K Témata

505.1 K Příspěvky

14 Online

82.9 K Uživatelé

Poslední Příspěvek: Support note: Prusament PLA Galaxy Black (March 13 – May 13) Nový Uživatel: minimalmule Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed