Notifications
Clear all
Omikron
Omikron
Skupina: Registrovaný
Přidal se: 2016/06/16
Estimable Member
4
Nothing. Extruder calibration has to be done by hand. Connec...

In forum Prusa i3 kit (Archive)

před 8 years
I can say from experience that even 1.5mm is WAAAAAY too muc...

In forum Others (Archive)

před 8 years
Apparently even a renamed LiquidCrystal library such as Adaf...

In forum Software (Archive)

před 8 years
PJR, you can't use the "latest" Arduino software to compile ...

In forum Software (Archive)

před 8 years
If you have a multimeter you can disconnect the limit switch...

In forum Prusa i3 kit (Archive)

před 8 years
Hmm, what's the latest version of Arduino this has been test...

In forum Software (Archive)

před 8 years
I was looking around for loose parts and noticed my y-axis p...

In forum Others (Archive)

před 8 years
I'm not sure if the MiniRambo can keep up if you increase th...

In forum Others (Archive)

před 8 years
Ta da: Click the P/N for the OEM site, click the price to g...

In forum Prusa i3 kit (Archive)

před 8 years
I'm having the same sound come from mine. Driving me nuts. I...

In forum Others (Archive)

před 8 years
Actually, 1 STL could contain separate shell models. Hmm, t...

In forum Software (Archive)

před 8 years
If I'm being honest, Natureworks 4043D is considered a entry...

In forum Print tips (Archive)

před 8 years
I'm looking forward to -- and have ordered -- the multi-mate...

In forum Software (Archive)

před 8 years
Converted them to STL (ASCII and Binary) and attached them t...

In forum Others (Archive)

před 8 years
Does this help: Peter Thank you Peter, it does! Looks l...

In forum Print tips (Archive)

před 8 years
Have you tried putting a very large box over the printer aft...

In forum Prusa i3 kit (Archive)

před 8 years
If someone can get what type of resin Prusa's filament uses ...

In forum Print tips (Archive)

před 8 years
Here's another discussion where people are talking about tol...

In forum Prusa i3 kit (Archive)

před 8 years
2. Switch it igus Drylin bearings - Note that these bearings...

In forum Prusa i3 kit (Archive)

před 8 years
This seems to be one of the most common problems on the foru...

In forum Prusa i3 kit (Archive)

před 8 years
Stránka 7 / 11
Share: