Notifications
Clear all
OGMaker
OGMaker
Group: Registered
Joined: 2019/03/09
Active Member
1
@swiss_cheese I gave up on the issue. I built a Voron 2.4 to...

In forum General discussion, announcements and releases

4 years ago
Connections checked and found no issues there. I have a spar...

In forum General discussion, announcements and releases

4 years ago
I cannot get the PC blend to stick to the bed at all! My MK3...

In forum General discussion, announcements and releases

4 years ago
Denatured Alcohol has methanol added to it (lethal to drink...

In forum Print tips (Archive)

5 years ago
@reddawg I agree with you on the MMU. As a point, the MMU co...

In forum General discussion, announcements and releases

5 years ago
I LOVE the textured sheet. Prusa could think about other pat...

In forum General discussion, announcements and releases

5 years ago
Pi0W works ok for me. I don't do video or time-lapse. I run ...

In forum Assembly and first prints troubleshooting

5 years ago
There is always a possibility that I muffed the assembly som...

In forum General discussion, announcements and releases

5 years ago
@charles-h13. I am looking forward to that. @nikolai-r, I b...

In forum General discussion, announcements and releases

5 years ago
Zero'd and formatted differently in statistics.

In forum General discussion, announcements and releases

5 years ago
@tim-m30, I am down to two printers, The MK3S and a Lulzbot ...

In forum General discussion, announcements and releases

5 years ago
I would add that I am very frustrated with the latest firmwa...

In forum General discussion, announcements and releases

5 years ago
I should add that this is an MK3/S with ~750 hours of print ...

In forum General discussion, announcements and releases

6 years ago
I find that after installing 3.7.1 Models that were printing...

In forum General discussion, announcements and releases

6 years ago
Share: