Activity
 
Notifications
Clear all
Nodak7
Nodak7
Group: Registered
Joined: 2024/11/22
Active Member
1
Filament Association on the MMU3

In forum General discussion, announcements and releases

3 weeks ago
Thanks again Bacon! I know that in the slicer these settings...

In forum General discussion, announcements and releases

1 month ago
Thanks for the reply Bacon! Seems to be the case. Where in t...

In forum General discussion, announcements and releases

1 month ago
Changing Printing Speed on MK4S with MMU3

In forum General discussion, announcements and releases

1 month ago
Thank you Ujin! This video really helps explain it a lot. Un...

In forum General discussion, announcements and releases

2 months ago
Is it better to change speed rather than put the printer in ...

In forum General discussion, announcements and releases

2 months ago
Changing Speed during Printing for overhang prints?

In forum General discussion, announcements and releases

2 months ago
Thanks I will have to check it out. They are kind of a odd s...

In forum General discussion, announcements and releases

3 months ago
Prusa Collet E3D for MMU3

In forum General discussion, announcements and releases

3 months ago
The PTFE is quite long at the moment. It is the stock length...

In forum Hardware, firmware and software help

3 months ago
Just a couple of questions. It appears part of my problem wa...

In forum Hardware, firmware and software help

3 months ago
It appears that you all were correct! It was my set-up that ...

In forum Hardware, firmware and software help

3 months ago
Thank you for the replies! I did correct a few tight bends b...

In forum Hardware, firmware and software help

3 months ago
MMU3 Issues - "Stuck Filament Detected"

In forum Hardware, firmware and software help

3 months ago
File Location

In forum General discussion, announcements and releases

4 months ago
Thank you. Yes it is "Wood" filament. I plan on putting the ...

In forum How do I print this? (Printing help)

9 months ago
What is the problem here?

In forum How do I print this? (Printing help)

9 months ago
Share: