Notifications
Clear all
nhand42
nhand42
Group: Registered
Joined: 2023/08/23
Estimable Member
4
I saw another post where their motor jumped 100 steps and it...

In forum How do I print this? (Printing help)

3 weeks ago
Your print looks good with those new supports, but with that...

In forum How do I print this? (Printing help)

3 weeks ago
IPA is to maintain a clean sheet between prints. Dish soap a...

In forum How do I print this? (Printing help)

3 weeks ago
Replace the block and the nozzle. Temp sensor and heater car...

In forum General discussion, announcements and releases

3 weeks ago
Your bed temp is way too low. Try 60C for bed, 215C for nozz...

In forum How do I print this? (Printing help)

3 weeks ago
The belts are near indestructible but I agree it is odd they...

In forum General discussion, announcements and releases

3 weeks ago
My tensioning bolt seized against the nut which made disasse...

In forum Assembly and first prints troubleshooting

4 weeks ago
I decided to upgrade my MK4S to the C1 because I knew the MK...

In forum General discussion, announcements and releases

4 weeks ago
My first week has been mostly positive. I had one disaster w...

In forum General discussion, announcements and releases

1 month ago
— From some exasperated mechanic’s dictionary, probably. I'l...

In forum General discussion, announcements and releases

1 month ago
The insert is 5.7mm long so that's a lot more threads in con...

In forum General discussion, announcements and releases

1 month ago
Belt Tensioner is NOT repair friendly

In forum General discussion, announcements and releases

1 month ago
There was a reddit post from Positron3d. They have various s...

In forum General discussion, announcements and releases

2 months ago
I'm getting some buzzing on fast movements. It seems to be r...

In forum Assembly and first prints troubleshooting

2 months ago
Nothing to worry about. PEI is a plastic sticker that is glu...

In forum Hardware, firmware and software help

2 months ago
Not from Prusa directly, but a third-party is putting togeth...

In forum General discussion, announcements and releases

2 months ago
Your part looks better than the original. Nice work. I remem...

In forum Awesome prints (Hall Of Fame)

2 months ago
Took me 2 hours to disassemble the MK4S and another 16 hours...

In forum General discussion, announcements and releases

2 months ago
I just finished my conversion kit and I'm happy with the Cor...

In forum General discussion, announcements and releases

2 months ago
I've watched the Jessy and CNC reviews. They're both glowing...

In forum General discussion, announcements and releases

7 months ago
Page 1 / 6
Share: