Nathan – Aktivita – Prusa3D Forum

Notifications

Clear all

Nathan

Skupina: Registrovaný

Přidal se: 2016/07/28

Trusted Member

	I fixed this by insulating the hotend with fiberglass insul... In forum Prusa i3 kit (Archive)	před 9 years
	Running the xyz calibration fixed the shift so all is good n... In forum Prusa i3 kit (Archive)	před 9 years
	Any ideas, I am going to try to do the entire calibration pr... In forum Prusa i3 kit (Archive)	před 9 years
	Shift towards front after updating to 3.0.7 In forum Prusa i3 kit (Archive)	před 9 years
	Am i correct that after updating the firmware I only need to... In forum Others (Archive)	před 9 years
	I am also using octo pi on a pi 3 hooked up to a webcam and ... In forum Software (Archive)	před 9 years
	Thanks for all the responses, I will play around with the se... In forum Print tips (Archive)	před 9 years
	I will try a different seam position but would there be any ... In forum Print tips (Archive)	před 9 years
	Strange Pattern on Print In forum Print tips (Archive)	před 9 years
	Quick update, insulating the hotend seems to have done the t... In forum Others (Archive)	před 9 years
	I will give that a whirl, thanks! In forum Others (Archive)	před 9 years
	I just started my first print sliced using the prusa flavor ... In forum Others (Archive)	před 9 years
	Introduction And Questions In forum Others (Archive)	před 9 years
	I will be receiving my printer tomorrow do I need to do some... In forum Others (Archive)	před 9 years

Stránka 3 / 3 Předchozí

Fórum Statistiky

595 Fóra

68.9 K Témata

481.7 K Příspěvky

13 Online

77.5 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed