Nathan – Aktywność – Prusa3D Forum

Notifications

Clear all

Nathan

Grupa: Zarejestrowany

Dołączył: 2016/07/28

Trusted Member

	I have looked through that guide, I will have to check on my... In forum Others (Archive)	8 years temu
	Help identify problem with print In forum Others (Archive)	8 years temu
	Stripped Bed Standoff In forum Prusa i3 kit (Archive)	8 years temu
	I mean lifting off the bed. In forum Others (Archive)	9 years temu
	I will try increasing the bed temp and see if that is enough... In forum Others (Archive)	9 years temu
	I will give that a try Peter, eventually i will get an enclo... In forum Others (Archive)	9 years temu
	I did not switch filaments, but my basement has gotten a lot... In forum Others (Archive)	9 years temu
	Prusa Slic3r more warp In forum Others (Archive)	9 years temu
	Thanks for the replies, did you have to change anything othe... In forum Print tips (Archive)	9 years temu
	The diameter averages to 1.75, I tried to reduce the print t... In forum Print tips (Archive)	9 years temu
	Hatchbox PLA Settings In forum Print tips (Archive)	9 years temu
	Nice! I am wondering if removing the power supply has any ne... In forum Improvements (Archive)	9 years temu
	Thanks for the link. My last printer was a Rostock Max V2 w... In forum Prusa i3 kit (Archive)	9 years temu
	Updatig PID values In forum Prusa i3 kit (Archive)	9 years temu
	I didn't build the printer, bought it assembled but since it... In forum Prusa i3 kit (Archive)	9 years temu
	That is the correct model heater block so you should be good... In forum Prusa i3 kit (Archive)	9 years temu
	That picture is the old style. In forum Improvements (Archive)	9 years temu
	I think the mk2 is using the new heater block so you should ... In forum Prusa i3 kit (Archive)	9 years temu
	E3D Hotend Insulators In forum Improvements (Archive)	9 years temu
	E3D finally released the covers for the v6 I would order the... In forum Prusa i3 kit (Archive)	9 years temu

Strona 2 / 3 Wstecz Następny

Statystyki Forum

585 Fora

68 K Tematy

476.8 K Posty

12 Online

75.7 K Członkowie

Ostatni Post: 6.4.0-alpha Firmware for Prusa CORE One Najnowszy użytkownik:: Tommy Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte