English
Forums
Members
Nathan
Activity
 
Notifications
Clear all
Nathan
Nathan
Group: Registered
Joined: 2016/07/28
Trusted Member
3
Profile Activity
I have looked through that guide, I will have to check on my...

In forum Others (Archive)

 8 years ago
Help identify problem with print

In forum Others (Archive)

 8 years ago
Stripped Bed Standoff

In forum Prusa i3 kit (Archive)

 9 years ago
I mean lifting off the bed.

In forum Others (Archive)

 9 years ago
I will try increasing the bed temp and see if that is enough...

In forum Others (Archive)

 9 years ago
I will give that a try Peter, eventually i will get an enclo...

In forum Others (Archive)

 9 years ago
I did not switch filaments, but my basement has gotten a lot...

In forum Others (Archive)

 9 years ago
Prusa Slic3r more warp

In forum Others (Archive)

 9 years ago
Thanks for the replies, did you have to change anything othe...

In forum Print tips (Archive)

 9 years ago
The diameter averages to 1.75, I tried to reduce the print t...

In forum Print tips (Archive)

 9 years ago
Hatchbox PLA Settings

In forum Print tips (Archive)

 9 years ago
Nice! I am wondering if removing the power supply has any ne...

In forum Improvements (Archive)

 10 years ago
Thanks for the link. My last printer was a Rostock Max V2 w...

In forum Prusa i3 kit (Archive)

 10 years ago
Updatig PID values

In forum Prusa i3 kit (Archive)

 10 years ago
I didn't build the printer, bought it assembled but since it...

In forum Prusa i3 kit (Archive)

 10 years ago
That is the correct model heater block so you should be good...

In forum Prusa i3 kit (Archive)

 10 years ago
That picture is the old style.

In forum Improvements (Archive)

 10 years ago
I think the mk2 is using the new heater block so you should ...

In forum Prusa i3 kit (Archive)

 10 years ago
E3D Hotend Insulators

In forum Improvements (Archive)

 10 years ago
E3D finally released the covers for the v6 I would order the...

In forum Prusa i3 kit (Archive)

 10 years ago
Page 2 / 3
Share: