English
Forums
Members
Nathan
Activity
 
Notifications
Clear all
Nathan
Nathan
Group: Registered
Joined: 2016/07/28
Trusted Member
3
Profile Activity
I have looked through that guide, I will have to check on my...

In forum Others (Archive)

 8 years ago
Help identify problem with print

In forum Others (Archive)

 8 years ago
Stripped Bed Standoff

In forum Prusa i3 kit (Archive)

 8 years ago
I mean lifting off the bed.

In forum Others (Archive)

 9 years ago
I will try increasing the bed temp and see if that is enough...

In forum Others (Archive)

 9 years ago
I will give that a try Peter, eventually i will get an enclo...

In forum Others (Archive)

 9 years ago
I did not switch filaments, but my basement has gotten a lot...

In forum Others (Archive)

 9 years ago
Prusa Slic3r more warp

In forum Others (Archive)

 9 years ago
Thanks for the replies, did you have to change anything othe...

In forum Print tips (Archive)

 9 years ago
The diameter averages to 1.75, I tried to reduce the print t...

In forum Print tips (Archive)

 9 years ago
Hatchbox PLA Settings

In forum Print tips (Archive)

 9 years ago
Nice! I am wondering if removing the power supply has any ne...

In forum Improvements (Archive)

 9 years ago
Thanks for the link. My last printer was a Rostock Max V2 w...

In forum Prusa i3 kit (Archive)

 9 years ago
Updatig PID values

In forum Prusa i3 kit (Archive)

 9 years ago
I didn't build the printer, bought it assembled but since it...

In forum Prusa i3 kit (Archive)

 9 years ago
That is the correct model heater block so you should be good...

In forum Prusa i3 kit (Archive)

 9 years ago
That picture is the old style.

In forum Improvements (Archive)

 9 years ago
I think the mk2 is using the new heater block so you should ...

In forum Prusa i3 kit (Archive)

 9 years ago
E3D Hotend Insulators

In forum Improvements (Archive)

 9 years ago
E3D finally released the covers for the v6 I would order the...

In forum Prusa i3 kit (Archive)

 9 years ago
Page 2 / 3
Share: