Activity
 
Notifications
Clear all
MTom
MTom
Group: Registered
Joined: 2019/01/06
Trusted Member
3
@fuchsr Oh, that looks great. I´ll give it a try.

In forum How do I print this? (Printing help)

4 years ago
@bnogler Yes I know I can not avoid them, I just thought of ...

In forum How do I print this? (Printing help)

4 years ago
@diem yes checked @bnogler Yes that does change something th...

In forum How do I print this? (Printing help)

4 years ago
Trouble on geometry edges (dents)

In forum How do I print this? (Printing help)

4 years ago
I´d say it loses power and restarts. Hard to say as it isn´t...

In forum Hardware, firmware and software help

4 years ago
Yes thanks, I did already check these, except for the voltag...

In forum Hardware, firmware and software help

4 years ago
Power Problem, PSU issue?

In forum Hardware, firmware and software help

4 years ago
Oh yes, thanks for the hint. I guess that was the reason, mu...

In forum Assembly and first prints troubleshooting

4 years ago
Argh yes I remember there was something. M502 / M500 I assum...

In forum Assembly and first prints troubleshooting

4 years ago
Too much filament extruded ? First layer fail.

In forum Assembly and first prints troubleshooting

4 years ago
I know, that is not the question, besides you don´t destroy ...

In forum General discussion, announcements and releases

4 years ago
@3delight Yes, like those just with the lock.

In forum General discussion, announcements and releases

4 years ago
Name of the stepper connectors on the Rambo board?

In forum General discussion, announcements and releases

4 years ago
Nah the filament type was right but I played a bit with the ...

In forum Assembly and first prints troubleshooting

4 years ago
Thanks neophyl, I´ll have a look at the other method, tried ...

In forum Assembly and first prints troubleshooting

4 years ago
What causes this testpattern error?

In forum Assembly and first prints troubleshooting

4 years ago
Yes you are right I had the head temperatures in mind.

In forum Hardware, firmware and software help

4 years ago
Headbed material? What is used as lamination material?

In forum Hardware, firmware and software help

4 years ago
Thanks, this is really helpful. However in my test it is at ...

In forum Assembly and first prints troubleshooting

4 years ago
Hmm okay, the max volumetric speed is set to 0 by default at...

In forum Assembly and first prints troubleshooting

4 years ago
Page 1 / 3
Share: