Prusa3D Forum

Notifications

Clear all

MrFlippant

Groupe: Enregistré

A(ont) rejoint: 2018/02/15

Trusted Member

	Same. They're probably still working on it. Dans le forum Prusa EasyPrint	il y a 7 months
	Best place for feedback? Dans le forum Prusa EasyPrint	il y a 7 months
	Post a photo or two Dans le forum Assembly and first prints troubleshooting	il y a 1 year
	Hey, if lead screws can spontaneously get bent, why not spon... Dans le forum Assembly and first prints troubleshooting	il y a 1 year
	Assembled... except not. You still had to install the tool d... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	I agree with the others. That doesn't look anything like ben... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	How much Z would we lose with that? Looks like maybe 10-20mm... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Yep. I did all those things, too. Without taking the bed bra... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Yep. It can happen on any machine with a hard link between t... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	I'm calling this one resolved. The replacement left z motor/... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Hopefully we see some of those things in an update to the ma... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Replacement motor has been shipped. Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Agreed, but it's not surprising that QC has slipped while th... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Yeah, I can understand why it is the way it is. It certainly... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	I contacted support and shared the images and videos. they h... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	As I expected, there is no visible or tactile defect or debr... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Thanks, guys! I'll check it out and report back. That looks ... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Thanks! I didn't think it was bent, so I took video from abo... Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	Z-banding or Z-wobble, do we have a solution yet? Dans le forum Assembly and first prints troubleshooting	il y a 2 years
	power cycling the printer and/or upgrading to the release ve... Dans le forum Bugs & Errors	il y a 2 years

Page 1 / 4 Suivant

Statistiques du forum

585 Forums

68.1 K Sujets

477.2 K Messages

10 En-ligne

75.8 K Membres

Le dernier des messages: The Cryogrip Pro Glacier plate is an excellent cheaper alternative to the Satin plate with one minor caveat on the Core One Notre nouveau membre: Tommy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé