|
So I have been doing a few prints with different filament sp... In forum Prusa i3 kit (Archive) |
7 years ago |
|
So maybe it's the new magnetic bed that gives this surface t... In forum Prusa i3 kit (Archive) |
7 years ago |
|
Hmm too tight, maybe, I guess I have been a bit worried it w... In forum Prusa i3 kit (Archive) |
7 years ago |
|
So after an hour of printing same issue, this time with loud... In forum Prusa i3 kit (Archive) |
7 years ago |
|
Alright I have just started a new print of the same part I h... In forum Prusa i3 kit (Archive) |
7 years ago |
|
I think you might be using a different slicer than me, I am ... In forum Prusa i3 kit (Archive) |
7 years ago |
|
Hmm I don't even have a "load config bundle" in prusa contro... In forum Prusa i3 kit (Archive) |
7 years ago |
|
oh alright, where do I find the ini file? Seems strange it's... In forum Prusa i3 kit (Archive) |
7 years ago |
|
Have you tried to sit and watch the print from start to end?... In forum Prusa i3 kit (Archive) |
7 years ago |
|
So a little update, haven't had much time to play around wit... In forum Prusa i3 kit (Archive) |
8 years ago |
|
The other screw is nice and tight, so since we last spoke I ... In forum Prusa i3 kit (Archive) |
8 years ago |
|
You say "the temperature was much more stable." That is very... In forum Prusa i3 kit (Archive) |
8 years ago |
|
The thermal set screw was actually a bit loose so I tightene... In forum Prusa i3 kit (Archive) |
8 years ago |
|
1. Tension on the extruder springs is set wrong (see above).... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Print is missing layers In forum Prusa i3 kit (Archive) |
8 years ago |
