Aktivita
 
Notifications
Clear all
mnk
mnk
Skupina: Registrovaný
Přidal se: 2025/05/25
Active Member
1
Finally someone else with this issue. Just today i was getti...

In forum Hardware, firmware and software help

před 3 months
There are plenty of other posts on this topic. 1. CHECK T...

In forum Hardware, firmware and software help

před 3 months
This is basically what i did too. I started doing this after...

In forum Assembly and first prints troubleshooting

před 5 months
I do have noise like that on the X axis only movements. Very...

In forum Assembly and first prints troubleshooting

před 5 months
FYI: my Belt tension went up after printer a 2:30h print by ...

In forum Assembly and first prints troubleshooting

před 5 months
This is all very specific and the behavior might only apply ...

In forum Assembly and first prints troubleshooting

před 5 months
Hard to imagine how this happened. Pictures of the faulty pa...

In forum Assembly and first prints troubleshooting

před 5 months
Imho you need to align the setup the gantry without belt ten...

In forum Assembly and first prints troubleshooting

před 5 months
To report goods news here, with another check after the prin...

In forum Assembly and first prints troubleshooting

před 5 months
I had to muck around with all that too. First just somehow p...

In forum Assembly and first prints troubleshooting

před 5 months
Dunno if its helps, but if you have done all the calibration...

In forum Assembly and first prints troubleshooting

před 5 months
Haha, this gave me a good scare. Thx for posting. This right...

In forum Assembly and first prints troubleshooting

před 5 months
Share: