Aktywność
 
Notifications
Clear all
MisterA
MisterA
Grupa: Zarejestrowany
Dołączył: 2017/12/15
Eminent Member
2
Hahaha, I'll take that as a compliment 🙂 Anyways, although ...

In forum Hardware, firmware and software help

5 years temu
Yes, initially I had clogs with the clicking noise. The init...

In forum Hardware, firmware and software help

5 years temu
Yes, the idler shaft is in the middle, no wobble.

In forum Hardware, firmware and software help

5 years temu
@Willieam I tried a fresh PLA spool right out of the airtigh...

In forum Hardware, firmware and software help

5 years temu
I tried this without success. What I also tried is this: I b...

In forum Hardware, firmware and software help

5 years temu
Another day, a new round of clicking... 🙁 I tried your sug...

In forum Hardware, firmware and software help

5 years temu
Another day, a new round of clicking... 🙁 I tried your sug...

In forum Hardware, firmware and software help

5 years temu
For what it's worth: did another test. I waited until the pr...

In forum Hardware, firmware and software help

5 years temu
Well to be honest I'm starting to regret I bought the MK3. I...

In forum Hardware, firmware and software help

5 years temu
The thing is: when I just got the printer I had the same iss...

In forum Hardware, firmware and software help

5 years temu
I checked this again: it's in the right place (right in the ...

In forum Hardware, firmware and software help

5 years temu
I'm reading 4080RPM.

In forum Hardware, firmware and software help

5 years temu
The heatbreak is tight to the heatsink. No heat sink paste.....

In forum Hardware, firmware and software help

5 years temu
I checked the gear on the motor, it was tightened on the fla...

In forum Hardware, firmware and software help

5 years temu
I will check immediately. I think it verifies that installin...

In forum Hardware, firmware and software help

5 years temu
Ok, so I took a picture of the latest jam I posted two video...

In forum Hardware, firmware and software help

5 years temu
Sigh... Another failed print. I went on to check on the prin...

In forum Hardware, firmware and software help

5 years temu
When I had a jam the printer was printing 'nothing' in the a...

In forum Hardware, firmware and software help

5 years temu
Hi Tim, I have since then put a lot more tension on the two ...

In forum Hardware, firmware and software help

5 years temu
As suggested I tried printing at 50% speed. No succes as you...

In forum Hardware, firmware and software help

5 years temu
Strona 1 / 2
Share: