|
Hahaha, I'll take that as a compliment 🙂 Anyways, although ... In forum Hardware, firmware and software help |
5 years ago |
|
Yes, initially I had clogs with the clicking noise. The init... In forum Hardware, firmware and software help |
5 years ago |
|
Yes, the idler shaft is in the middle, no wobble. In forum Hardware, firmware and software help |
5 years ago |
|
@Willieam I tried a fresh PLA spool right out of the airtigh... In forum Hardware, firmware and software help |
5 years ago |
|
I tried this without success. What I also tried is this: I b... In forum Hardware, firmware and software help |
5 years ago |
|
Another day, a new round of clicking... 🙁 I tried your sug... In forum Hardware, firmware and software help |
5 years ago |
|
Another day, a new round of clicking... 🙁 I tried your sug... In forum Hardware, firmware and software help |
5 years ago |
|
For what it's worth: did another test. I waited until the pr... In forum Hardware, firmware and software help |
5 years ago |
|
Well to be honest I'm starting to regret I bought the MK3. I... In forum Hardware, firmware and software help |
5 years ago |
|
The thing is: when I just got the printer I had the same iss... In forum Hardware, firmware and software help |
5 years ago |
|
I checked this again: it's in the right place (right in the ... In forum Hardware, firmware and software help |
5 years ago |
|
I'm reading 4080RPM. In forum Hardware, firmware and software help |
5 years ago |
|
The heatbreak is tight to the heatsink. No heat sink paste..... In forum Hardware, firmware and software help |
5 years ago |
|
I checked the gear on the motor, it was tightened on the fla... In forum Hardware, firmware and software help |
5 years ago |
|
I will check immediately. I think it verifies that installin... In forum Hardware, firmware and software help |
5 years ago |
|
Ok, so I took a picture of the latest jam I posted two video... In forum Hardware, firmware and software help |
5 years ago |
|
Sigh... Another failed print. I went on to check on the prin... In forum Hardware, firmware and software help |
5 years ago |
|
When I had a jam the printer was printing 'nothing' in the a... In forum Hardware, firmware and software help |
5 years ago |
|
Hi Tim, I have since then put a lot more tension on the two ... In forum Hardware, firmware and software help |
5 years ago |
|
As suggested I tried printing at 50% speed. No succes as you... In forum Hardware, firmware and software help |
5 years ago |
