Notifications
Clear all
Miquel Adell
Miquel Adell
Group: Registered
Joined: 2018/01/01
Trusted Member
3
Factory reset - memory wipe - new calibration fixed it. A b...

In forum Hardware, firmware and software help

6 years ago
Fan error on second layer

In forum Hardware, firmware and software help

6 years ago
to continue on what @david.s139 is pointing out I also tried...

In forum Others (Archive)

6 years ago
well, it did not work for me. I cut a new PTFE tube with c...

In forum Others (Archive)

6 years ago
The clip did not solve my clicking so I'll go back, disassem...

In forum Others (Archive)

6 years ago
Hi, I dissasssembled and reassembled the hot end to try to ...

In forum Others (Archive)

6 years ago
I wasn't seeing that because I was not logged in at the stor...

In forum Hardware, firmware and software help

6 years ago
Where to find a heat cartridge replacement

In forum Hardware, firmware and software help

6 years ago
wop, that was caused by octolapse, a plugin to capture timel...

In forum Hardware, firmware and software help

7 years ago
Extruder moving to the side after each layer

In forum Hardware, firmware and software help

7 years ago
Hi @austin.a2 my prusa mk3 (purchased january, shipped march...

In forum Hardware, firmware and software help

7 years ago
Do you have a video showing the skipping? Is it like this? ...

In forum Hardware, firmware and software help

7 years ago
I mentioned that in another thread, I had to re-run the Wiza...

In forum Hardware, firmware and software help

7 years ago
Temperature and part fan speed not kept after filament runou...

In forum Hardware, firmware and software help

7 years ago
I'm very new with slic3r (mostly use s3d), but does it suppo...

In forum How do I print this? (Printing help)

7 years ago
How to enforce support for the first layers with Slic3r and ...

In forum How do I print this? (Printing help)

7 years ago
this happened a lot to me. When slic3r repairs errors someti...

In forum How do I print this? (Printing help)

7 years ago
I ended up "merging" this issue with another one I had becau...

In forum Hardware, firmware and software help

7 years ago
Understanding clicking on your MK3

In forum Hardware, firmware and software help

7 years ago
Guys thanks for the feedback, I will ask our developer to en...

In forum Software (Archive)

7 years ago
Page 1 / 3
Share: