|
Temperatures according to the display on the unit were the s... In forum Hardware, firmware and software help |
9 months ago |
|
I guess it will remain a mystery. ¯\_(ツ)_/¯ In forum Hardware, firmware and software help |
9 months ago |
|
I only expected a difference for that layer, maybe two, not ... In forum Hardware, firmware and software help |
9 months ago |
|
I was printing PLA so no chamber temperature set. It was onl... In forum Hardware, firmware and software help |
9 months ago |
|
Not complaining at all, just unsure why the difference exist... In forum Hardware, firmware and software help |
9 months ago |
|
And to be clear - I'm not upset or complaining, just wonderi... In forum Hardware, firmware and software help |
9 months ago |
|
Another closer picture.
60b70c3b-img_7647.jpeg In forum Hardware, firmware and software help |
9 months ago |
|
Visible difference after power failure recovery (60 seconds)... In forum Hardware, firmware and software help |
9 months ago |
|
The belts do not have to be the same length. One being longe... In forum Assembly and first prints troubleshooting |
10 months ago |
|
Any chance you took before-and-after pictures of the pulley?... In forum Assembly and first prints troubleshooting |
10 months ago |
|
They could try how mine shipped, 125hz on the right, 80hz on... In forum Assembly and first prints troubleshooting |
10 months ago |
|
I meant on your replacement. What's going on with your curr... In forum Assembly and first prints troubleshooting |
10 months ago |
|
Make sure to check belt tension first thing and if it's un-e... In forum Assembly and first prints troubleshooting |
10 months ago |
|
For what it's worth I had a Core One delivered via FedEx in ... In forum Assembly and first prints troubleshooting |
10 months ago |
|
I believe it's already aluminum, but it seems really soft. ... In forum Assembly and first prints troubleshooting |
10 months ago |
|
Aha, I wish I had found this thread yesterday. I did mine t... In forum Assembly and first prints troubleshooting |
10 months ago |
