Čeština
Fóra
Uživatelé
Mike Daneman
Aktivita
 
Notifications
Clear all
Mike Daneman
Mike Daneman
Skupina: Registrovaný
Přidal se: 2019/08/05
Estimable Member
4
Profile Aktivita
I was originally considering doing the internal pi as descri...

In forum User mods - OctoPrint, enclosures, nozzles, ...

 před 5 years
MMU2S Feedback

In forum Hardware, firmware and software help

 před 5 years
Hi guys, Sorry, it took me a bit long than I expect, but I w...

In forum General discussion, announcements and releases

 před 5 years
Couple of question on Prusa Slicer filament change options

In forum General discussion, announcements and releases

 před 5 years
I ran into a similar issue shortly after I got my MK3S. I d...

In forum How do I print this? (Printing help)

 před 5 years
If I use a Pi 3, can I still connect it directly to the Eins...

In forum User mods - OctoPrint, enclosures, nozzles, ...

 před 5 years
Setting up Octoprint on MK3S

In forum User mods - OctoPrint, enclosures, nozzles, ...

 před 5 years
Thanks for all the advice. I already made some improvements...

In forum General discussion, announcements and releases

 před 5 years
Tim, Thanks for your advice as well. I'm not sure if this h...

In forum General discussion, announcements and releases

 před 5 years
Joan, Thanks a lot for your advice (on both the first layer ...

In forum General discussion, announcements and releases

 před 5 years
Advice on first layer

In forum General discussion, announcements and releases

 před 5 years
MK3S filament movement/jam detection?

In forum Hardware, firmware and software help

 před 5 years
Thanks guys. Ordered the collet from Amazon and it should b...

In forum Hardware, firmware and software help

 před 5 years
Melted the plastic collet in heatsink, what's the best way t...

In forum Hardware, firmware and software help

 před 5 years
Stránka 10 / 10
Share: