Mike C – Aktivita – Prusa3D Forum

Notifications

Clear all

Mike C

Skupina: Registrovaný

Přidal se: 2016/05/30

Eminent Member

	Working with support we found that if I took the extruder co... In forum Prusa i3 kit (Archive)	před 8 years
	Extuder not able to reach 255 In forum Prusa i3 kit (Archive)	před 8 years
	Thanks for the responses, I will recheck my wiring again and... In forum Prusa i3 kit (Archive)	před 8 years
	When printing PLA, the fans kicks in and the temp will not g... In forum Prusa i3 kit (Archive)	před 8 years
	Overshooting temps causing thermal runaway In forum Prusa i3 kit (Archive)	před 8 years
	I tried putting G80 into the long running commands and the p... In forum General discussion, announcements and releases	před 9 years
	So the Slic3r build that comes with the MK2 is a custom buil... In forum Software (Archive)	před 9 years
	Good to know, thanks for looking into this. I also need one,... In forum Others (Archive)	před 9 years
	Curious, since Simplify3d is commercial if we should be bang... In forum General discussion, announcements and releases	před 9 years
	Any chance we can create a github repo so we can keep track ... In forum General discussion, announcements and releases	před 9 years
	Any chance we can setup a Github repo so we can be sure we a... In forum Print tips (Archive)	před 9 years

Stránka 2 / 2 Předchozí

Fórum Statistiky

579 Fóra

65.9 K Témata

461.5 K Příspěvky

23 Online

73.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed