Notifications
Clear all
MiguelAngP
Group: Registered
Joined: 2016/10/20
Active Member
1
| Impresora similar en prestaciones? | 2 years ago | |
| Upload filament causing filament bits | 5 years ago | |
| Z-axis layers issue | 6 years ago | |
| Last hours have been cleaning the hole system (extruder feed... | 6 years ago | |
| I think I've found the most probably issue causing the print... | 6 years ago | |
| @andrew-d44 how do you disassemble the hotend? any guide onl... | 6 years ago | |
| @andrew-d44 Yes, first two prints were fine but I am not abl... | 6 years ago | |
| @andrew-d44 Exactly same issue here.. no possible to print A... | 6 years ago |