|
In case anyone else needs it, here's another source I found: In forum Others (Archive) |
9 years temu |
|
Thanks, David. It helps a lot knowing that there's an "offic... In forum Others (Archive) |
9 years temu |
|
Need Replacement Fan In forum Others (Archive) |
9 years temu |
|
My nozzle gouge was not that bad, but I'll relay my story so... In forum Others (Archive) |
9 years temu |
|
The way I look at it, I was going to build a reprap, open so... In forum Others (Archive) |
9 years temu |
|
I just double-checked, and I had the correct profile. So it ... In forum Print tips (Archive) |
10 years temu |
|
Hmm, I'll have to check. I may have just selected the wrong ... In forum Print tips (Archive) |
10 years temu |
|
Pillowing on 0.05mm DETAIL profile In forum Print tips (Archive) |
10 years temu |
|
Thanks, Peter! That's important to know. It means when I sli... In forum Others (Archive) |
10 years temu |
|
Both legs on mine broke, too, but it definitely wasn't an ad... In forum Prusa i3 kit (Archive) |
10 years temu |
|
Question about Flow Rate In forum Others (Archive) |
10 years temu |
|
Thanks! I changed the z-lift setting to start from 0mm, and ... In forum Prusa i3 kit (Archive) |
10 years temu |
|
Well, I thought everything was great with my first layer, bu... In forum Prusa i3 kit (Archive) |
10 years temu |
|
However, the issue does appear to have been resolved in 3.0.... In forum Others (Archive) |
10 years temu |
|
This statement is in the change log for 3.0.7:
We received ... In forum Others (Archive) |
10 years temu |
|
I tried that procedure that I linked to above, using my Prus... In forum Print tips (Archive) |
10 years temu |
|
To be completely honest this should be in the improvement se... In forum Print tips (Archive) |
10 years temu |
|
I found the following page and thought I might try it starti... In forum Print tips (Archive) |
10 years temu |
|
Thanks! I'll take a look at that. In forum Print tips (Archive) |
10 years temu |
|
New filament tips? In forum Print tips (Archive) |
10 years temu |
