|
In case anyone else needs it, here's another source I found: Im Forum Others (Archive) |
Vor 9 years |
|
Thanks, David. It helps a lot knowing that there's an "offic... Im Forum Others (Archive) |
Vor 9 years |
|
Need Replacement Fan Im Forum Others (Archive) |
Vor 9 years |
|
My nozzle gouge was not that bad, but I'll relay my story so... Im Forum Others (Archive) |
Vor 9 years |
|
The way I look at it, I was going to build a reprap, open so... Im Forum Others (Archive) |
Vor 9 years |
|
I just double-checked, and I had the correct profile. So it ... Im Forum Print tips (Archive) |
Vor 9 years |
|
Hmm, I'll have to check. I may have just selected the wrong ... Im Forum Print tips (Archive) |
Vor 9 years |
|
Pillowing on 0.05mm DETAIL profile Im Forum Print tips (Archive) |
Vor 10 years |
|
Thanks, Peter! That's important to know. It means when I sli... Im Forum Others (Archive) |
Vor 10 years |
|
Both legs on mine broke, too, but it definitely wasn't an ad... Im Forum Prusa i3 kit (Archive) |
Vor 10 years |
|
Question about Flow Rate Im Forum Others (Archive) |
Vor 10 years |
|
Thanks! I changed the z-lift setting to start from 0mm, and ... Im Forum Prusa i3 kit (Archive) |
Vor 10 years |
|
Well, I thought everything was great with my first layer, bu... Im Forum Prusa i3 kit (Archive) |
Vor 10 years |
|
However, the issue does appear to have been resolved in 3.0.... Im Forum Others (Archive) |
Vor 10 years |
|
This statement is in the change log for 3.0.7:
We received ... Im Forum Others (Archive) |
Vor 10 years |
|
I tried that procedure that I linked to above, using my Prus... Im Forum Print tips (Archive) |
Vor 10 years |
|
To be completely honest this should be in the improvement se... Im Forum Print tips (Archive) |
Vor 10 years |
|
I found the following page and thought I might try it starti... Im Forum Print tips (Archive) |
Vor 10 years |
|
Thanks! I'll take a look at that. Im Forum Print tips (Archive) |
Vor 10 years |
|
New filament tips? Im Forum Print tips (Archive) |
Vor 10 years |
