Mick – Activité – Prusa3D Forum

Notifications

Clear all

Mick

Groupe: Enregistré

A(ont) rejoint: 2017/12/15

Trusted Member

	Mini limitations Dans le forum General discussion, announcements and releases	il y a 5 years
	Ebay now full of Prusa I3 Mk2S - FROM CHINA!!! Dans le forum General discussion, announcements and releases	il y a 7 years
	What is the current wait time as an estimate? Dans le forum General discussion, announcements and releases	il y a 7 years
	The issue is that the prints were done on the same machine, ... Dans le forum Others (Archive)	il y a 7 years
	I wish they would do a double hot end MMU for twin material ... Dans le forum Others (Archive)	il y a 7 years
	Thanks for your help, it is appreciated! Dans le forum Others (Archive)	il y a 7 years
	What changed this print quality? Dans le forum Others (Archive)	il y a 7 years
	I am currently using an Mk2 and wondered what the advantages... Dans le forum Others (Archive)	il y a 7 years
	But what difference do they make? Dans le forum Others (Archive)	il y a 7 years
	What is the difference between a Mk2 and a Mk2S? Dans le forum Others (Archive)	il y a 7 years
	Thanks Nathan, Can a larger power PSU be added by just swap... Dans le forum Others (Archive)	il y a 7 years
	Guys, Thank you so much for your opinions. I am going to go... Dans le forum Others (Archive)	il y a 7 years
	I3 Mk3 - Max temp on hot end and heat bed Dans le forum Others (Archive)	il y a 7 years
	David, Thanks for the reply. I work with acoustics and tha... Dans le forum Others (Archive)	il y a 7 years
	Can you mount the power supply unit away from the frame of ... Dans le forum Others (Archive)	il y a 7 years
	2500 hours of print time does seem a lot for something that ... Dans le forum Others (Archive)	il y a 7 years
	As an owner of both as well I can tell you that it depends o... Dans le forum Others (Archive)	il y a 7 years
	As an owner of both as well I can tell you that it depends o... Dans le forum Others (Archive)	il y a 7 years
	For any business use case stay away, or wait a few months fo... Dans le forum Others (Archive)	il y a 7 years
	This is great information and I thank you all for taking the... Dans le forum Others (Archive)	il y a 7 years

Page 2 / 3 Précédent Suivant

Statistiques du forum

565 Forums

63.9 K Sujets

447.6 K Messages

18 En-ligne

69.5 K Membres

Le dernier des messages: How do I set the GCODE macros to not raise the printhead so much? Notre nouveau membre: SilenceDIY Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé