Prusa3D Forum

Notifications

Clear all

michael.c31

Skupina: Registrovaný

Přidal se: 2017/08/06

Eminent Member

	so as a follow up to this it appears that the problem was th... In forum Assembly and first prints troubleshooting	před 6 years
	sorry about these not being on the build plate. It kind of g... In forum Hardware, firmware and software help	před 6 years
	Layer Shifts In forum Hardware, firmware and software help	před 6 years
	Update: No more jamming on my extruder after replacing MK2.5... In forum Assembly and first prints troubleshooting	před 6 years
	my mistake. i was referring to the PTFE tube that sits in th... In forum Assembly and first prints troubleshooting	před 6 years
	There are various work-arounds for this already posted here.... In forum Assembly and first prints troubleshooting	před 6 years
	so nice update. the PTFE tube ended up getting stretched out... In forum Assembly and first prints troubleshooting	před 6 years
	it failed again with a tip that measures at 2.03mm ramming a... In forum Assembly and first prints troubleshooting	před 6 years
	it failed again with a tip that measures at 2.03mm ramming a... In forum Assembly and first prints troubleshooting	před 6 years
	it seemed to help with stringy tips at normal / suggested pr... In forum Assembly and first prints troubleshooting	před 6 years
	started another print and red had a problem right off the ba... In forum Assembly and first prints troubleshooting	před 6 years
	started another print and red had a problem right off the ba... In forum Assembly and first prints troubleshooting	před 6 years
	i am wondering about going back a a 2.0mm hot end tube. Ar... In forum Assembly and first prints troubleshooting	před 6 years
	getting stuck in the PTFE tube in the hotend is a symptom an... In forum Assembly and first prints troubleshooting	před 6 years
	getting stuck in the PTFE tube in the hotend is a symptom an... In forum Assembly and first prints troubleshooting	před 6 years
	the green was not in use it was the white filament. and i ha... In forum Assembly and first prints troubleshooting	před 6 years
	The green one look pretty bad for PLA. Try with lower temp o... In forum Assembly and first prints troubleshooting	před 6 years
	the filament i am using is inland PLA. and the tips measure ... In forum Assembly and first prints troubleshooting	před 6 years
	i am going to high jack this post as i think i am in the sam... In forum Assembly and first prints troubleshooting	před 6 years
	The extruder motor current was set to a rather high value (3... In forum Hardware, firmware and software help	před 6 years

Stránka 1 / 2 Další

Fórum Statistiky

565 Fóra

63.9 K Témata

447.7 K Příspěvky

19 Online

69.5 K Uživatelé

Poslední Příspěvek: Xl extruder stops Nový Uživatel: Mechman0124 Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed